Planning Installation - Vissani QR814 Manual Del Usario

Pre-Installation (continued)

PLANNING INSTALLATION

Number of people required: 2 strongly recommended .
1 . Choose a location for your range hood . The range hood location
should be away from strong draft areas, such as windows, doors,
and strong heating vents .
2 . Measure all distances to ensure the proper position of the range
hood (A) and chimney set (B, C) .
- The size of the range hood installation location must have
a width (1) of at least 29.5 in. (750 mm) and a depth (2) of
at least 19.7 in. (500 mm) to accommodate the size of the
range hood (A) .
- The minimum distance (3) from the cooking surface to
the range hood is 24" (610 mm). If your range specifies a
different distance, use the greater distance of the two . For
best performance, distance (3) should not exceed 36 in
(914 mm).
3 . Supplied mounting hardware can be used to secure the hood
to most wall types. However, a qualified technician must verify
suitability of the supplied mounting hardware for your wall type .
4 . Due to the size and weight of this range hood, the supports must
be firmly attached to the wall. For plaster or sheet rock walls, the
support must be attached to the studs . If this is not possible, a
support structure must be built behind the plaster or sheet rock .
5 . Put a thick, protective covering over your counter, cooktop, or
range to protect it from damage and dirt during installation .
Remove any hazardous objects around the area .
Please contact vissani@conglom.com or 1-888-449-9197 between 8:30 am - 5 pm, EST, Monday - Friday for further assistance.
WARNING:
Always wear safety goggles and gloves during
installation .
NOTE:
Do not remove the plastic covering on the chimney set at this time,
as it protects the chimney set from scratches during installation.
C
B
A
3
Fig. 2
7
2
1