Installation - Wired Doorbell - HAMPTON BAY HB-7622-03 Guía Para El Uso Y Cuidado

Installation - Wired Doorbell

Verifying the transformer
1
power rating
Power must be supplied from a 16 volt AC, 10 or 15 watt
transformer.
WARNING: This doorbell requires a low voltage electrical
connection. Do not connect directly to 120V AC.
2
Removing the existing doorbell
Remove the cover from the existing doorbell
and label all wires with masking tape before
disconnecting:
"F" - Front door push button wire
"T" - Transformer wire
"R" - Rear door push button wire (if
applicable)
3
Mounting the doorbell
Route the wires through the wire entrance hole
in the doorbell base (B).
Using the "UP" arrow indicator, place the
doorbell base (B) against the wall and mark
the four screw hole locations.
Drill four 7/32 in. pilot holes and insert wall
anchors (BB).
Attach the doorbell base (B) to the mounting
surface using the four screws (AA) and tighten
securely.
4
Wiring the doorbell
Connect the doorbell wires to the doorbell
base (A):
Wire "F" to screw terminal "FRONT"
Wire "T" to screw terminal "TRANS"
Wire "R" to screw terminal "REAR"
Snap the doorbell cover (A) onto the doorbell
base (B).
NOTE: DO NOT install batteries if connecting doorbell to
transformer wires.
Disconnect all wires from existing doorbell and
remove doorbell from mounting surface.
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
1 SECOND.
FRONT TRANS REAR
F
5
Please contact 1-844-760-3644 for further assistance.
T
O N
F R
S
A N
T R
A R
R E
AA
FRONT TRANS REAR
R
HAMPTONBAY.com
B
B