Operation - HAMPTON BAY HB-7622-03 Guía Para El Uso Y Cuidado

Installation - Wireless Doorbell
4
Mounting the doorbell base
Using the "UP" arrow indicator, place the
doorbell base (B) against the wall and mark
the four screw hole locations.
Drill four 7/32 in. pilot holes and insert wall
anchors (BB).
Attach the doorbell base (B) to the mounting
surface using the four screws (AA) and tighten
securely.
Snap the doorbell cover (A) onto the doorbell
base (B).

Operation

1
Adjusting the doorbell volume
The doorbell base (B) has an adjustable volume
control. Rotate the volume control to adjust the
volume.
Selecting a musical tune -
2
wired doorbell
The doorbell has different selectable tunes. The push
button connected to the "REAR" terminal will only play
Ding-Dong (two note tune). The push button connected
to the "FRONT" terminal will play any of the musical
tunes.
Press and release the "TUNE" button on the
doorbell base (B) until the desired "FRONT" tune
is heard.
3
Setting wireless push buttons
Wireless push buttons have two options for tune
selection: Play the selected "FRONT" door musical
tune or play the "REAR" door designated tune (Ding-
Dong).
Push buttons come from the factory with no
jumper installed on the pins. This setting will
play the "FRONT" door musical tune.
To set a push button to play only the Ding-
Dong ("REAR") tune, add the jumper to the pins
inside the push button.
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
1 SECOND.
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
1 SECOND.
ON
1
1 2
Push button set as
"FRONT" door – no
jumper on the pins
(Factory Default)
7
Please contact 1-844-760-3644 for further assistance.
AA
B
FRONT TRANS REAR
B
B
ON
1
1 2
Push button set as
"REAR" door – jumper
is on the pins
HAMPTONBAY.com