DeWalt DW085 Traducido De Las Instrucciones Originales página 50

ENGLISH
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and
applicable regulations.
• Always mark the center of the laser dots.
• Make sure the tool has been set up securely.
• Extreme temperature changes cause movement of internal parts that
may affect the accuracy of the tool. Regularly check the accuracy
while using the tool under these circumstances.
• Although the tool corrects small out-of-level errors automatically, when
it is bumped, re-adjustment to balance or set-up may be required.
• If the tool has been dropped or has tipped over, have the laser head
calibrated by a qualified repair agent.
Low Battery Indicator (fi g. 2)
The DW085 is equipped with a low battery indicator (b), as shown in
Figure 2. The red indicator light is located on top of the tool. When the
light flashes, the batteries are low and need to be replaced. The laser may
continue to operate for a short time while the batteries continue to drain.
After fresh batteries are installed and the laser is turned on again, the red
indicator light will stay off. (A flashing laser beam is not caused by low
batteries; refer to Out of Tilt Range Indicator.)
Turning the Laser On and Off (fi g. 1)
With the laser off, place it on a stable, flat surface. Turn the laser on by
rotating the on/off lever (c) so it points up. It will then project five beams;
one up (d), one down (e), one horizontal to the left, (f), one horizontal to the
right (g), and one horizontal to front (h).
To turn the laser off, rotate the on/off lever (c) down to its horizontal
position. Beams will no longer be projected.
Locking Pendulum (fi g. 1)
The DW085 is equipped with a locking pendulum mechanism. This feature
is only activated when the laser is switched off. When the on/off lever (c) is
48