Wm6M Handheld Transmitter; Wm6H Bodypack Transmitter - PROEL WM600 Manual De Usuario

12. FREQUENCY BAND
In this label, together with the general data of the receiver, you can find the receiving radio frequency
band.
WM6M HANDHELD TRANSMITTER
See FIG. 2 at page 16:
1. MICROPHONE GRID
The grid protects the microphone capsule and include a pop filter. Type of microphone capsule is
dynamic with a cardioid unidirectional figure.
2. SET BUTTONS
Up and down buttons to set the transmitting channel.
3. ON OFF
On/off switch, downward the microphone is off, upward the microphone is on. There is a middle position
where the microphone is on but it is muted, useful in case you don't want to hear the typical switching
on/off click.
4. CHANNEL NUMBER
The display shows the channel number, that must correspond to the channel set on the receiver
Note: when a flashing [LO] text appears, the batteries are near to be exhaust, to indicate that they must
be replaced as soon as possible.
5. BATTERIES COVER
Sliding down the lower part of the microphone body you can access to the battery inlet.
6. BATTERIES INLET
To operate the microphone needs 2 type AA alkaline batteries.
Note: the microphone is able to operate also with 2 Ni‐MH rechargeable batteries, but in this case the
operating time is less.
7. FREQUENCY
On the back side of the batteries inlet an adhesive shows the frequency band of the transmitter.
(The figure shows some optional accessories available from the PROEL catalogue.)
WM6H BODYPACK TRANSMITTER
See FIG. 3 at page 16:
1. AUDIO INPUT
3,5mm mini jack input socket to connect the supplied microphones.
2. OFF MUTE ON
On/off switch, downward the microphone is off, upward the microphone is on. There is a middle position
where the microphone is on but it is muted, useful in case you don't want to hear the typical switching
on/off click.
3. ANTENNA
This is the transmitting integral antenna: do not force, try to disconnect, or replace with other one.
4. CHANNEL NUMBER
The display shows the channel number, that must correspond to the channel set on the receiver
Note: when a flashing [LO] text appears, the batteries are near to be exhaust, to indicate that they must
be replaced as soon as possible.
5. BATTERIES COVER
Sliding down the lower part of the bodypack you can access to the battery inlet.
6. SET BUTTONS
Up and down buttons to set the transmitting channel.
7