Power Supply Unit - Astralpool PULIT E 90 Instrucciones Para El Usuario

English

3. Power supply unit

Digital, "Switch-Mode" power supply:
Input - 100-250 AC Volts
50-60 Hertz
180 Watt
Output - 30 VDC
IP 54
Section 2 – Pulit E90 Pool Cleaner Operation
Part 1 – Preparing the Pulit E90 Pool Cleaner for Use
A. Assemble the Caddy kit – you will find the instructions in a separate document
B. Adjusting the handle float angle
The handle angel must be adjusted to determine the speed that the Pulit E90 advances along the water-line
1. Lay the handle down at an angle of 180º to
the ground.
2. Push the base of the arm into the body of the
Pulit E90 and slide it towards the rear of the
Pulit E90 until it clicks into the required position.
Normal advance
More efficient cleaning action on water-line.
Fast advance
Fast speed – For faster but less efficient cleaning
action on water-line.
On/Off
switch
Push in here
Slide here
Full Filter
Bag Indicator
Reset button
Slide here
Push in here
4
Delay
Indicator