Astralpool PULIT E 90 Instrucciones Para El Usuario página 6

English
Turning on the Pulit E90 on
1. Plug the floating cable from the pulit E90
into the power supply unit.
2. Plug the electrical cable from the power
supply unit into the mains.
3. Press the ON/OFF switch on the power
supply unit.
4. The Pulit E90 will now start to work.
Part 3 – Taking the Pulit E90 out of the water
Unplug power supply before any servicing activity.
1. If the Pulit E90 has not finished its cycle, turn off the power supply
unit and unplug the mains.
2. Pull the floating cable gently until the Pulit E90 has risen to the
surface, then lift by the handle.
Important: Do NOT lift the Dolphin from the water by its cable.
Floating cable
On/Off
switch
6