Emergency Procedure; General Safety Information - Gude GSE 5501 DSG Manual Del Usuario

ENGLISH
34

Emergency procedure

Conduct a first-aid procedure adequate to the injury
and summon qualified medical attendance as quickly
as possible. Protect the injured person from further
harm and calm them down. If you seek help, state the
following pieces of information: 1. Accident site, 2.
Accident type, 3. Number of injured persons, 4. Injury
type(s)
Connection, installation and
operation
AVR
Automatic voltage control makes sure the
unit voltage fluctuation is within the values
guaranteed by the power plant.
Caution: Before using the product it is essential
to check whether the appliance is suitable to be
operated with the unit. Specifications of the ap-
pliance must always match the details and safety
instructions of the unit.
As far as electronically controlled equipment is con-
cerned, it is necessary to ask in advance for informati-
on from the producer (HIFI, PC, TV, cameras, electronic
hand equipment with continuous control or e.g.
chargers) as the electric generator does not produce
perfect sinusoid (due to the combustion engine).
Due to possible voltage fluctuation, we recommend
not connecting any electronic equipment such as HiFi
appliances or TV and PC as they could get damaged!
Do not connect the appliance before the unit is run-
ning at full speed. Disconnect the appliance before
turning the unit off.
Never connect another appliance when there is
one being operated. This would inevitably lead to
fluctuations able to destroy electronically controlled
equipment.
The electric energy consumption is the critical point
of an induction appliance ehen starting. Electric
energy consumption can be 3-5 times higher than the
rated power that must necessarily be considered.

General safety information

WARNING
Read all safety warnings and all instructions. Failu-
re to follow the warnings and instructions may result
in electric shock, fire and/or serious injury. Save all
warnings and instructions for future reference.
Keep children and bystanders away while operating a
power tool. Minimum safe distance is 5 m.
Never let children work with the appliance. Never let
adults work with the appliance unless they have been
properly trained.
Wear personal protective equipment.
Never plug 2 units at the same time.
No change can be made in respect of engine and unit
setting.
It is strictly prohibited to disassemble, modify
and purposely remove the protective equipment
on the unit and fit other protective equipment
instead.
The appliance must not be used if damaged or
safety equipment is defective. Replace any
worn-out and damaged parts.
Fuel is highly flammable. Refuel the engine only when
switched off. The appliance may only be refuelled
outdoors and not near open fire or burning cigarettes.
Make sure the fuel does not overflow. If the fuel
overflows, the engine must not be started. Remove
any dirt from the appliance and prevent any attempt
at ignition until fuel fumes have evaporated..
Oil products must not come into contact with skin,
eyes and clothing.
Some parts of the appliance get too hot when the
appliance is operated. Do not touch any hot parts, e.g.
engine and muffler. Contacting hot parts of the unit
may cause burns. Pay attention to the warnings on
the advice.
Exhaust gases, fuel and lubricants are toxic. Do not
operate the unit in closed spaces where dangerours
carbon monoxide gases may accumulate.
When operating the generator in rooms with good
ventilation, the exhaust gases must be channeled di-
rectly outdoors through an exhaust hose.
WARNING! Toxic exhaust gases can escape despite
the exhaust hose. Due to the fire hazard, never direct
the exhaust hose towards inflammable materials.
Electrical safety
Check the device and its electrical components
(including cables and plug connections) before use to
make sure that there are no defects present.
The power generator may not be connected to other
power sources, such as the power supply of the public
grid. In specific cases, where a back-up connection
to existing electrical systems is provided for, this may
be done only by a qualified electrician, who takes
into account the differences between the equipment
operated on the public grid and the operation of the
power generator.
Do not connect the unit with other energy sources.
Do not connect the unit to home network.