Bamix Basic Modo De Empleo página 12

Mounting and changing attachments
All attachments feature a recess (figure 1).
Recess
The drive shaft stub of the bamix
(figure 2).
Drive pin
Push the attachment as straight as possible onto the stub so
that the drive pin engages in the recess on the attachment.
Please make sure that the attachment is exactly parallel to the
cutter guard and properly aligned with the stub (figures 3/4).
Mount and remove attachment
To remove the attachment, just pull it from the stub.
If the attachment cannot be easily pulled off, loosen it by placing the
bamix in hot soapy water and switching the appliance on briefly.
®
Disconnect the power plug from the socket and pull off the attachment.
If necessary, lever it off with a suitable implement (e.g. screwdriver).
vertically
Before changing the attachment, disconnect the
power plug of the appliance from the power plug. Do
not touch rotating attachments.
22
is equipped with a drive pin
®
Receptacles
You can use the bamix in any receptacle, even directly in a
®
pan on the hob. Use small receptacles for small amounts and large
receptacles for larger amounts. Narrow, high receptacles are
more suitable for the bamix than wide, shallow ones.
®
When using receptacles other than those supplied with your
bamix , ensure that they do not have an inward curved base.
®
Otherwise, the curved container base might come into contact
with the moving attachment, causing damage.
Risk of splashing and injury from scalding.
Never attempt to clean appliance by tapping the mixer base
or shaft against the edge of the pan. Only tap it against your
hand.
23