How To Assemble; How To Disassemble - Richell Elite Manual De Instrucciones

How to assemble

1.
Attach Panels
① Locate the hole on the bottom of the Panel
and insert the Wood Dowel on the Coupling
Rod in the direction as shown.
2.
Insert Holepins
Insert 2 Hole pins in to the Holes
on top of the Coupling Rods as
shown.
Hole pin
Hole
How to open/close Door
l Grip and lift the Upper Gate Lock so that
the Gate Door is opened by releasing
Upper and Lower Gate Locks.
l The product is designed to lock automatically
when closed. If too much or too little force is
used when closing, the Gate Door may not
lock.

How to disassemble

① Remove Caps.
② Remove Hole Pins as shown.
③ Slide Panel forward to separate from Coupling Rod
as shown.
(Do not force by pulling or twisting Coupling Rod.)
Cautions!
l Take care that product does not collapse while
disassembling.
l Leave Door locked when assembling Door Panel.
Specifications
UPC/JAN 803840 30000-8 / 4973655 50670-7
803840 30002-2 / 4973655 50673-8
Dimension 33.9"W x 1.4"D x 31.7"H
Materials Frame: Natural Wood (Rubber Wood, Lacquer Finish)
Metal Part/Wire: Steel (Polyester coating) Cap: Nylon Lock: Polypropylene
lPlease note that product specifications and design may change without prior notice for the purpose of quality improvement.
lThere may be some joint war page and each product may experience different coloration in the wood grain of the wood as frames are made of
natural material.
lIf you find something wrong with this product, please let us know. Thank you!
When use as pet pen, maximum of 4 panels can be connected to make each side of a pen.
Do not connect more than 5 panels on each side.
Wood Dowel
Hole
3.
Insert Caps
After selecting your desired configuration,
insert Caps as shown. Check to make sure
each Cap is in position.
Cautions!
l Caps can only be inserted
at 90 or 180 degree angles.
l There will be a small gap
between Panel and Cap.
② Attach the top of the Coupling Rod to the Panel as shown.
(After inserting Wood Dowel, do not force the Coupling Rod by
twisting/turning).
Upper Gate Lock
803840 30001-5 / 4973655 50671-4
803840 30003-9 / 4973655 50672-1
Rubber Skid: Elastomer
2
90 degree angle 180 degree angle
Lower Gate Lock
Designed by:
Richell Corporation, Japan
Distributed by:
Richell USA, Inc.
Grand Prairie, Texas 75050
Phone (972) 641-9795 Fax (972) 641-8495
www.richellusa.com
Visit us at
MADE IN VIETNAM