Tune The Speaker - Advent ADVW801 Manual De Instalación Y Operación

ADVW801_instructions_trilingual 1/6/04
NOTE If the light does not flicker, confirm secure
connection of the AC Adapter. If the light still does
not flicker, confirm secure connection to the audio
source output. If there is still no response, leave the
Output Level Control Wheel completely turned to the
left (as shown on the previous page) and see the
following NOTE.
9 ADVENT ADVW801 900 MHz Wireless Outdoor/Indoor Speaker System
4:05 PM Page 10
NOTE If the transmitter is connected to a variable
output (i.e., headphone jack, TV audio output on the
audio source, leave the Output Level Control Wheel
turned all the way to the left (as shown on previous
page) and adjust the volume on the audio source up
or down as necessary to make the Audio Level
Indicator Light flicker intermittently. If you are
unclear as to the kind of output (variable or fixed)
you are using, please see More Helpful Information
on page 12.

Tune the Speaker

Adjust the speaker as follows:
Turn On and Tune the Speaker
A Use the speaker Power ON-OFF/Volume Control
Knob (A) to turn the speaker "ON." The Power
Indicator Light (B) will turn red.
Turn the Tuning Control Knob (F) until your audio
B
source is clearly heard through the speaker,
indicating the speaker is tuned to the signal from
the transmitter. With the volume up, you should
now be able to hear the audio source.
Adjust Volume (A) as desired.
C
NOTE Interference in the form of static and/or
distortion can sometimes be heard.
If this occurs, confirm the transmitter/speaker
adjustments and indicators. If the problem persists,
Power ON-OFF/
refer to the Troubleshooting section of this
Volume Control
Knob (A)
manual.
ADVENT ADVW801 900 MHz Wireless Outdoor/Indoor Speaker System
Tuning Control
Knob (F)
Power Indicator
Light (B)
10