Before Initial Operation - Flex RD10.8/18.0/230 Instrucciones De Funcionamiento Originales

Safety instructions for handling
batteries
■ Do not open the battery. Short-circuiting
hazard!
■ Protect the battery against heat, including
prolonged sunshine, fire, water and
moisture. Explosion hazard!
■ A damaged or incorrectly used battery may
result in the emission of fumes. Ensure a
supply of fresh air and consult a doctor if
you feel unwell. The fumes may irritate the
respiratory tracts.
■ Liquid may leak out of the battery if the
battery is incorrectly used. Avoid contact
with such liquid. If contact accidentally
occurs, rinse affected area with water. If
liquid contacts eyes, seek medical attention.
Liquid discharged from the battery may
cause irritation or burns.
■ Recharge batteries only with chargers
recommended by the manufacturer. A
charger that is suitable for one type of
battery may create a fire hazard when used
with another battery.
■ The battery may be damaged by pointed
objects such as e.g. nails or screwdrivers
or by external application of force. This may
give rise to an internal short circuit, causing
the battery to burn, smoke, explode or
overheat.
NOTE
Follow the instructions for charging the battery
set out in the charger operating manual.
Important information
Please observe the regulations in the country
of use regarding the payment of radio licence
fees.

Before initial operation

Unpack the device and check that there are no
missing or damaged parts.
Installing or removing battery
cartridge
CAUTION!
Always switch off the radio before removing the
battery cartridge.
To open the battery compartment ② , lift up the
battery compartment locker ① first, then open
16
the battery compartment as shown in FIG. B.
For installing battery cartridge, align the tongue
on the battery cartridge with the groove in the
housing and slip it into place. Always insert it all
the way until it locks in place with a little "click".
Do not use force when installing the battery
cartridge. If the cartridge does not slide in easily,
it is not been inserted correctly (FIG. C).
To remove the battery cartridge, open the
battery compartement as described in FIG. B.,
push the battery release button.
To close the battery compartment, close battery
compartment cover and hold it, then press the
battery compartment locker as shown in FIG. D
Using supplied AC power adaptor (4)
Insert the AC power adaptor plug into the AC/
DC socket (3) on the back side of the radio.
Plug the adaptor into a standard mains socket
outlet. Whenever the adaptor is used, the
battery pack is automatically disconnected. The
AC adaptor should be disconnected from the
main supply when not in use.
NOTE
The battery cartridge is not charged by using the
power adaptor.
Switching the device on and off
Switching on (FIG. E):
Press the On/Off button (12) and hold for
2 seconds. The device switches on. The
background illumination of the display (11)
lights up.
Switching off:
Press the On/Off button and hold for 2 seconds.
The device switches off.
Standby mode (FIG. F)
When the device is switched on, briefly press
On/Off button, the device switchs to standby
mode and back light disappears. During
standby mode, briefly press On/Off button to
switch on the device. During standby mode any
function is unavailable.
RD10.8/18.0/230