Maintenance And Care; Spare Parts And Accessories - Flex RD10.8/18.0/230 Instrucciones De Funcionamiento Originales

Tuning (DAB)
When the device is first switched on in DAB
mode, the radio will auto scan to find broadcast
stations in the local area.
Briefly press the
to scroll through the stations. Press
to select.
Finding new stations (DAB) (FIG. M)
From time to time, new DAB radio stations may
become available. Or you may have moved to a
different part of the country. In this case you may
need to activate your radio to scan for new stations.
press the button. Your radio will perform
a full scan of the DAB frequencies. As new
stations are found, the station counter on the
left side in the display will increase and stations
will be added to the list.
Manual tuning(FM): Briefly press the
button to set the desired frequency. Each
press will increase or decrease 0.05MHZ. The
frequency is shown in the display.
Scan Tuning (FM): Press the
button and hold for 3 seconds, the tuner
frequency will increase to seek the first radio
station with acceptable clarity and stop at
that station. The frequency is shown in the
display. The right arrow button may be pressed
again to continue seeking a radio station at
higher frequencies. The left arrow button may
be pressed to seek radio stations at lower
frequencies. The search function is only
available in FM mode.
Storing stations in preset memories
(DAB and FM) (FIG. N)
There are 5 memory presets for each
waveband.
Press and hold the desired Preset button (15) until
the preset number is shown on the display. The
station is then stored in the selected Preset button.
Repeat this procedure for the remaining presets.
Stations stored in the preset memories can
be overwritten by following the procedures
described above.
To recall stations from the preset memories,
briefly press the desired Preset button while
device is in radio mode. The preset number
and station frequency will appear in the display.
18
or button (10a or 10b)
button
or

Maintenance and care

WARNING!
Before carrying out work of any kind (cleaning,
transport, storage), remove the battery from the
device.
CAUTION!
Never clean plastic parts with solvents or other
aggressive fluids. This could damage the
device.
Cleaning
Clean the device with a dry cloth or brush.
Repairs
Repairs must be carried out by an authorized
customer service centre only.

Spare parts and accessories

Other accessories can be found in the
or
manufacturer's catalogues. You can find
exploded drawings and spare part lists on our
homepage:
www.flex-tools.com/Disposal Information
EU countries only
Do not throw electric power tools into
the household waste! In accordance
with the European Directive 2012/19/
EU on Waste Electrical and Electronic
Equipment and transposition into
national law used electric power tools
must be collected separately and
recycled in an environmentally friendly
manner.
Raw material recovery instead of waste
disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for recycling
according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal options!
RD10.8/18.0/230