edc COUGAR Guía De Instalación Y Funcionamiento página 5

GB
Testing
Fill the drain pan with clean tap water until the water level is approximately half way up
the COUGAR
The COUGAR
purged from the system.
Continue to fill the drain pan until the water level reaches the Alarm On level (Fig. 3.).
The alarm contacts should open.
Allow the COUGAR
reset when the water level gets close to the bottom of the
Pump Off).
Trouble Shooting
Pump does not run:
Check fuse and electrical supply
connections.
Check water level is high enough to start
the pump.
Pump is noisy:
Check that the
and outlet tube are not vibrating against
the sides of the drain pan and that there is
no debris in the bottom of the drain pan.
Pump continues to run with no water:
The water sensor can become over
sensitive if contaminated by dirt or certain
cleaning chemicals. If this occurs,
disconnect the
supply and flush the sensor housing with
clean tap water for around 30 seconds
(Fig. 4.). If the problem persists, flush with
methylated spirit and then rinse with
water.
WARRANTY
This product is guaranteed for two years to be free from manufacturing defects or
faulty materials. If it should fail for either of these reasons within two years from the
date of manufacture it will be repaired or replaced free of charge, at the option of EDC
International Limited.
EDC International Limited can accept no liability whatsoever for any loss or damage
arising from the use of this product, however caused. Before using this product the
user should satisfy himself that it is suitable for use in the intended application and for
the manner in which it is intended that it be used.
This product is subject to continuous development and improvement and EDC
International Limited reserves the right to alter the specification or design without prior
notice.
4
body (Fig. 3. Pump On).
should start to pump. It may be noisy initially until any air has been
to empty the drain pan. The pump should stop and the alarm relay
COUGAR , mains cable
COUGAR from the mains
COUGAR
Pump is pumping air:
Check that the COUGAR
level.
Check that the outlet tube is not
syphoning.
body (Fig. 3.
is flat and
Fig. 4.