Install Drain Tailpiece
4
WARNING: Do not lift or move the bathtub without assistance. A
!
cast iron bathtub is extremely heavy and may cause personal injury.
WARNING: When moving the bathtub be sure to use the transfer
!
belts as shown in the figure.
WARNING: Provide adequate support under the bathtub feet.
!
Complete the installation
5
Dry fit the drain plumbing.
•
Secure the bathtub. Mark the bathtub's feet positions. Apply a general
•
purpose adhesive (not included) or a clear silicone (not included) in the
marks. Each foot should have a 2-3/8" (60 mm) diameter area of ad-
hesive. NOTE: Both floor and tub feet should be clear of all dirt, dust
and debris before applying adhesive.
Remove the transfer belts.
•
Permanently connect the drain plumbing.
•
Fill the bathtub with water to the overflow and then drain the
•
bathtub while inspecting the waste connections for leaks.
Clean the installation site. Clean the surrounding floor. Clean
the bathtub using a mild detergent.
Standard drain with tailpiece below the floor
WARNING: Do not use acidic or alkaline base products to clean the bathtub. Damage to
!
the enamel surface may occur.
Be sure to clean the bathtub after each use. Dirt may stain the bathtub if left for long periods.
•
Use mild detergent, a soft cloth and a sponge. Follow only the installation instructions for your
•
particular model/installations.
Before using the bathtub place a small amount of cold water into the bathtub. Then add hot wa-
•
ter. If the hot water is 80 ºC (176 ºF) and used directly the bathtub can become damaged.
Avoid water containing sulfur. This will discolor the bathtub.
•
Installation (continued)
Bathtub Maintenance
Drain with tailpiece above the floor
(using accessory fitting)