Publicidad
Idiomas disponibles
Idiomas disponibles
Key:
Start signal delay
Key:
Not ready: error
Key:
Save signal
Key:
I/O Profile
Network
Keys:
,
,
,
For more information, please see the separate manual.
Password
Keys:
,
,
,
Operation
Password
Key:
Protection configuration
Key:
Protection favorites
Key:
Protection memory card
Intermittent mode only
Indication in time per second of the delay for the start signal.
Value range: 0.00 ... 9.99.
On: If a print order is active but the direct print module is not ready to process the order (e.g. if it
is already in 'printing' mode), then an error message appears.
Off: No error message appears.
Speed only: If the print speed falls below the minimum, an error message is displayed.
Intermittent mode only
On: The start signal for the next label can already be released during printing the current label.
The signal is registered from the printing system. The printing system starts printing the next
label immediately after finishing the current one. Therefore time can be saved and performance
be increased.
Off: The start signal for the next label can only be released if the current label is printed to the
end and the printing system is again in 'waiting' state (output 'ready' set). If the start signal was
released already before, so this is ignored.
Selection of the existing configuration Std_Direct or StdFileSelDirect. The appropriate
assignment is indicated in the operating manual.
,
,
,
,
,
,
,
,
Entering a 4-digit numeric password.
Printer settings can be changed (contrast, speed, operating mode, ...). The password
protection prevents modifications at the printer settings.
The password protection prevents the access to the favorites.
With the functions of the memory card, labels can be stored, loaded, etc. The password
protection has to decide if no access or only readable acces on CF card is allowed.
No protection: No password protection
Userview only: Only reading access
Protected: Access blocked
English
,
Flexicode
125
Publicidad
Capítulos
