Taking A Measurement - Health O Meter 7632 Manual De Instrucciones

Taking a Measurement

1. Press the "User Selection" button to select Memory Zone 1 or Memory Zone 2.
The measurement that you take will automatically be stored in the Zone selected.
2. Place the cuff on the wrist. Press the "ON/OFF/START" button
will light up, checking the display functions. The checking procedure
will be completed after about 2 seconds.
3. After all symbols appear, the display will show a blinking "0". The monitor is
"Ready to Measure" and will automatically inflate the cuff to start measurement.
This monitor will re-inflate automatically to approximately 220mmHg if the system
detects that your body needs a higher pressure to measure your blood pressure.
OR
13
. All digits