Lectura De Las Memorias - Health O Meter 7632 Manual De Instrucciones

4. When the measurement is completed, systolic, diastolic, and pulse will be
shown simultaneously and be saved automatically into the memory. The
measurement is then automatically stored into the pre-designated memory
zone. The last 50 measurement readings will be saved into each memory.
Note:
1. This monitor automatically switches off approximately 1 minute after
the last button operation.
2. To interrupt the measurement, simply press any key. The cuff will deflate
immediately after a key is pressed.
3. During the measurement, do not talk or move your arm or hand muscles.
Recalling Values from Memory
1. The monitor has two memory zones (1 and 2). Each zone can store up to
50 measurements.
2. To recall blood pressure readings from memory, use
the "User-Selection" button to select the appropriate
Memory Zone (1 or 2) from which to recall the readings.
Once the proper zone is selected, press the "M" button.
The memory values will be shown on the LCD display.