Additional Information On Replacing The Power Supply - Axis T92A00 Guia De Instalacion

Page 10

Additional information on replacing the power supply

Note:
The power supply is pre-installed in the AXIS T92A00 housing.
1. Remove the screws holding the yellow/green cables.
2. Attach the power supply brackets loosely, using the supplied screws.
3. Slide the power supply in place and tighten the screws making sure that the yellow/green
cables are still attached.
4. Connect the power supply connector (fig.7).
Power supply
connector
Power supply
brackets
yellow/green cables
and holders
FIG.7
AXIS T92A00 Installation Guide
power supply
Connector