Inserting/Replacing The Battery - Flex CI 11 18.0 Instrucciones De Funcionamiento Originales

18V Flex Lithium Battery
Rated
Pack or 12V
voltage
Vehicle Power
Maximum air
11 BAR / 1100 kPa /160 PSI
pressure
Air flow 800 L/min
Overview (see figure A)
The numbering of the product features refers
to the illustration of the machine on the
graphics page.
1 BAR + Button
2 Handle
3 Digital Pressure Gauge
4 Start/Pause Button
5 Mode Button
6 Power Button
7 LED On/Off Button
8 BAR – Button
9 High Pressure Hose
10 Air-Chuck Clamp
11 Presta Valve Adapter
12 Air Chuck
13 Tapered Adapter
14 Sports Needle Adapter
15 LED Work Lights
16 High Volume Hose
17 Air Intake
18 12V Vehicle Connector and Cord
19 Pinch Valve Adaptor
20 High Volume Air Output
21 Vehicle Connector and Cord Cover
22 Battery Level Indicator Button
23 Battery-Release Button
Operating instructions
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power
tool
Unpack the dual function inflator and check
that there are no missing or damaged parts.
14
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger operating
manual.

Inserting/replacing the battery

■ Press the charged battery into the power
tool until it clicks into place.
■ To remove, press the release button (23)
and pull out the battery. (see figure B)
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may short-
circuit the contacts; explosion and fire hazard!
Battery level indicator
(see figure C)
Press the battery level indicator button (22) to
show the current battery level (see figure C1)
NOTE
• When the lowest level of the battery
indicator starts flashing after pressing button,
the battery is empty. (see figure C2)
• When 2 levels of the battery indicator start
flashing after pressing button, the battery
is not within the allowable operating
temperature range. (see figure C3)
Car socket connection
(see figure D)
■ As alternative to a battery pack, the car
socket can be used as power supply.
■ Remove the vehicle connector and cord
cover (21) from the back of the inflator.
■ Remove the car socket adapter (18) from
the storage compartment.
■ Connect adapter to the car socket On/off.
Inflating with the High-pressure
hose (see figure E)
The air chuck (12) on the high-pressure hose
can be used without adapters to inflate tires
or other items that have a valve stem that fits
the air-chuck opening.
■ Unlock the air chuck clamp (10)
■ Place the air chuck (12) on valve stem
NOTE
For Presta and Dunlop valves screw the
adapter on the valve stem before placing the
air chuck
CI 11 18.0