Noise And Vibration; Technical Specifications - Flex CI 11 18.0 Instrucciones De Funcionamiento Originales

CI 11 18.0
■ Never direct a jet of compressed air
toward people or animals. Take care not
to blow dust and dirt towards yourself or
others. Following this rule will reduce the
risk of serious injury.
■ Protect your lungs. Wear a face or dust
mask if the operation is dusty. Following
this rule will reduce the risk of serious
personal injury.
■ Do not use this inflator to spray
chemicals. Your lungs can be damaged by
inhaling toxic fumes.
■ Check damaged parts. Before further use
of the inflator or air tool, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended function.
Check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting, and any other conditions that
may affect its operation. A guard or other
part that is damaged should be properly
repaired or replaced by a SKIL factory
service center or authorized FLEX service
station. Following this rule will reduce the
risk of shock, fire, or serious injury.
■ Do not crush, drop or damage the battery
pack. Do not use a battery pack or charger
that has been dropped or received a sharp
blow. A damaged battery is subject to
explosion.
■ Properly dispose of a dropped or
damaged battery immediately.
■ Do not charge a battery tool in a damp
or wet location. Following this rule will
reduce the risk of electric shock.
■ Allow pump to cool for five (5) minutes
after each fifteen (15) minutes of
continuous use.
■ Never block the inflating or deflating
outlets while operating.
■ Save these instructions. Refer to them
frequently and use them to instruct others
who may use this handheld inflator. If you
loan someone this handheld inflator, loan
them these instructions also.

Noise and vibration

The noise and vibration values have been
determined in accordance with EN 62841.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
– Total vibration value:
– Emission value a
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in
EN 62841 and may be used to compare one
tool with another.
It may be used for a preliminary assessment
of exposure. The declared vibration emission
level represents the main applications of the
tool. However if the tool is used for different
applications, with different accessories or
poorly maintained, the vibration emission
may differ. This may significantly increase the
exposure level over the total working period.
For a precise estimation of the vibration load
the times should also be considered during
which the power tool is switched off or even
running, but not actually in use. This may
significantly decrease the exposure level over
the total working period. Identify additional
safety measures to protect the operator from
the effects of vibration such as: maintain the
tool and the accessories, keep the hands
warm, organisation of work patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A)

Technical specifications

Dual function inflator
Battery AP 18.0/2.5 AP 18.0/5.0
Working
-10~40℃
temperature
Storage
-40~70℃
temperature
Charging
4~40℃
temperature
: XXX dB(A);
pA
: XXX dB(A);
WA
K = 3.0 dB.
: XXX m/s
h
K = 1.5 m/s
N!
2
2
13