ASROCK 939S56-M Manual Del Usuario página 16

2.8 2.8 2.8 Making a SA Making a SAT T T T T A Driver Disk Making a SA
2.8 2.8 Making a SA Making a SA
"RAID" Mode "RAID" Mode "RAID" Mode "RAID" Mode "RAID" Mode
If you want to install Windows 2000, Windows XP, or Windows XP 64-bit OS on your
SATA HDDs with RAID functions, you will need to make a SATA driver before you
start the OS installation.
STEP 1: Insert the ASRock Support CD into your optical drive to boot your system.
(Do NOT insert any floppy diskette into the floppy drive at this moment!)
STEP 2: During POST at the beginning of system boot-up, press <F11> key, and
then a window for boot devices selection appears. Please select CD-
ROM as the boot device.
STEP 3: When you see the message on the screen, "Do you want to generate
Serial ATA driver diskette [YN]?", press <Y>.
STEP 4: Then you will see these messages,
Please insert a diskette into the floppy drive.
WARNING! Formatting the floppy diskette will
lose ALL data in it!
Start to format and copy files [YN]?
Please insert a floppy diskette into the floppy drive, and press <Y>.
STEP 5: The system will start to format the floppy diskette and copy SATA drivers
into the floppy diskette.
Once you have the SATA driver diskette ready, you may start to install Windows 2000
/ Windows XP / Windows XP 64-bit on your system directly without setting the RAID
configuration on your system, or you may start to use "SiS RAID BIOS Setting Utility"
to set RAID 0 / RAID 1 / JBOD configuration before you install the OS. Before you start
to configure the RAID function, you need to check the installation guide in the Support
CD for proper configuration. Please find the document, "Guide to SATA Hard Disks
Installation and RAID Configuration", at the following path in the Support CD:
.. \ RAID BIOS Setting Utility
You may also set the RAID configuration by using "SiS RAID Utility for Windows" in
Windows environment. Please refer to the document in the Support CD, "Guide to SiS
RAID Utility for Windows", which is located in the folder at the following path:
.. \ RAID Utility for Windows
2.9 2.9 2.9 2.9 2.9 SAT T T T T A Operating in "non-RAID" Mode SA SA SA SA A Operating in "non-RAID" Mode A Operating in "non-RAID" Mode A Operating in "non-RAID" Mode A Operating in "non-RAID" Mode
If you want to install Windows 2000, Windows XP, or Windows XP 64-bit OS on your
SATA HDDs operating in non-RAID mode, you don't need to make a SATA driver
diskette before OS installation.
Windows 98 SE and Windows ME must be installed by SATA operating in
RAID mode, and you don't need to make a SATA driver diskette for these
two OS before OS installation.
1 6 1 6 1 6
1 6 1 6
A Driver Diskette F A Driver Disk A Driver Disk ette For SA ette F ette F
A Driver Disk ette F
ASRock 939S56-M Motherboard
or SA or SAT T T T T A Operation in or SA A Operation in A Operation in A Operation in
or SA A Operation in