Important Safety Precautions; Initial Start-Up - Martin Yale 698 Instrucciones De Uso

GB
<< The machine may not be operated by more
than one person at any given time!
The machine was designed for safe operation
by "one person only".
<< During the shredding process no other
work may be performed on the machine
(for example cleaning, etc.).
<< Keep children away from the machine.
This machine's design and safety concept
are based on adult dimensions (inlet guide,
safety cut-off switches, etc.) to ensure that it
can be operated safely by adults only.
<< Repairs may only be performed by trained
personnel.
APPLICATION:
The 14.95 shredder is used in all areas where
large quantities of printed material need to be
shredded.
The machine can shred cardboard and crumpled
paper as easily as it shreds smooth paper.
3 4 5
2 1
fig. 7

IMPORTANT SAFETY PRECAUTIONS

INITIAL START UP
CAUTION: The shredder should only
be fed with paper or cardboard!
Shredding other data carriers can cause
injury(e.g. by splintering of hard materials)
or may damage the shredder (e.g.
destruction of the cutting system).
Make sure that no loops occur when
feeding strip material. Danger of in-
jury!
POWER SUPPLY CONNECTION:
a) The maximum value for loop impedance at the
mains connection point is 0.5 Ohms.
b) The conductor cross-section of the power supply
line should be of a magnitude so as to cause a
15% voltage drop in the case of a machine
blockage (inhibit current = 3 x nominal current).
<< Keep all loose articles of clothing,
ties, jewelery, long hair or other
loose objects away from opening,
injury may result!
<< Never insert fingers into opening.
Serious injury may result!
<< In case of danger switch the machine
STOP
off with the mains switch, or with the
emergency switch, or unplug the
machine.
<< Always unplug the machine from the
mains power supply before opening the
machine.
CHECKING THE RUNNING DIRECTION:
1. Switch on the main switch (1) (fig. 8); i.e. to
2. Place rotary switch (2) in position „1" (fig. 7).
3. Check that the shredder is running in the correct
Now that everything has been correctly assembled
and connected, you can proceed to operating the
machine.
7
position „1".
direction and correct the phase relation of the
power plug if necessary.
Correcting the phase relation of the
power plug may only be carried out
by a qualified electrician!
14.95