Moulinex AEP Serie Manual Del Usuario página 11

If there is a problem
PROBLEM CAUSES
Water drips from The chosen temperature is too low
the holes in the and does not allow the formation of
soleplate. steam.
You are using steam while the iron is
not hot enough.
You are using the Shot of Steam
button
There is too much steam selected.
You have stored the iron
horizontally, without emptying it and
without setting it to
Brown streaks You are using chemical descaling
come through the agents.
soleplate and stain
You are not using the right type of
the linen.
water.
Fabric fibres have accumulated in
the holes of the soleplate and are
burning.
Your linen has not been rinsed
sufficiently or you have ironed a
new garment before washing it.
The soleplate is You are ironing with an
dirty or brown and inappropriate setting (temperature
can stain the linen. too high).
You are using starch.
There is little or no The water tank is empty.
steam.
Your iron has a build-up of scale.
Your iron has been used dry for too
long.
The soleplate is You have placed your iron flat on a
scratched or metallic rest-plate or ironed over a
damaged. zip.
Steam or water
The steam control is not set to
comes out from the
The water tank is overfilled.
iron as you finish
filling the tank.
There is not enough water in the
*
The spray does
water tank.
not spray.
If you have any problem or queries, please contact our Customer Relations team first for expert help and
advice:
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
*
depending on model
*
too often.
.
Helpline:
0845 602 1454 - UK / (01) 4610390 - Ireland
Or consult our Website: www.moulinex.co.uk
11
SOLUTIONS
Set the thermostat knob in the steam range
(from •• to MAX).
Wait until the thermostat light goes out.
Wait a few seconds between each use of
the button.
Reduce the steam rate.
Always store your iron on its heel. Adjust the
steam button on dry
Do not add any descaling agents to the
water in the water tank.
Perform a self-cleaning operation
consult the section "What type of water to
use?".
Perform the self-cleaning operation
clean the soleplate with a damp sponge.
Vacuum the holes of the soleplate from time
to time.
Make sure that your laundry is rinsed
sufficiently so as to remove any deposits of
soap or chemical products on new clothes.
Clean the soleplate with a non-metallic
sponge. Select the appropriate setting.
Always spray starch onto the reverse side of
the fabric.
Fill it.
Carry out a self-clean
Carry out a self-clean
Always set your iron on its heel.
. Check that the steam control is set to
Never overfill the water tank. Empty out the
excess.
Fill up the water tank.
position.
*
and
*
and
*
.
*
.
.
EN