Sulzer ABS RW 480 Instrucciones De Instalación Y Funcionamiento página 7

•
Loosen the screws of the clamping element (3/6) and withdraw the propeller together with the clamping element. Remove o-ring (3/7)
out of groove.
Assembly
•
Clean carefully the shaft and boss. Insert new o-ring (3/7) into the boss groove and lightly oil the shaft and clamping element (3/6).
ATTENTION Do not use any products containing molybdenum disulphide!
•
Evenly / slightly tighten the screws of the clamping element in a crosswise sequence.
•
Finally tighten fully going from side to side with a tightening torque of 16 Nm. Then check tightening torque in a crosswise sequence.
•
Put lock washers (3/3) together with o-ring (3/4), propeller washer (3/2) and o-ring (3/5) on socket head screw (3/1) and tighten with
17 Nm.
5.3 Tightening torque
See chapter 5.3 of the Installation and Operating Instructions 6006183 / 6005672.
5.4 Installation example RW 480
We recommend that the closed bracket be used for this type of installation
7
6
5
4
5.5 Brackets RW/SB-KA
See chapter 5.5 of the Installation and Operating Instructions 6006183 / 6005672.
5.6 Guide tube lengths (square tube) RW/SB-KA
See chapter 5.6 of the Installation and Operating Instructions 6006183 / 6005672. RW 480 ≙ RW 900.
5.7 Electrical connection
See chapter 5.8 of the Installation and Operating Instructions 6006183 / 6005672. See figure 32. Chapter 5.8.3 is not relevant to RW 480.
6 - 7 Commisioning; Maintenance
See chapter 6 - 7 of the Installation and Operating Instructions 6006183 / 6005672.
EN 6184-E
1
2
3
Figure 4 Installation example RW 480
Legend
1 Hoist with winch and rope
2 Upper bracket with locking plate
3 Closed bracket
4 Bottom plate
5 Safety stop clamp
6 Swivelling square guide tube
7 Cable clamp with cable hook
7