Electrical Installation - ORDISI IG-65W Manual De Uso De Mantenimiento

4. - INSTALLATION
4.1. - UNPACKING
Upon reception of the equipment, if package is seen as damaged, immediately check if device has been affected. When
device is checked and damages are confirmed, immediately refer then to the technical service for a review and be sure
that not any internal failure has happened.
4.2. - MOUNTING
4.2.1.- INSTALLATION OF WALL PLATE
The assembly and installation of lamp IG-65W must take place under the mounting instructions in this manual and be
undertaken only by personnel of ORDISI or authorized assemblers. A bad installation of it may have the effect of loose
during operation, and this can cause serious injury to the patient and health personnel.
The type of the fixture described in this manual is designed for a wall with brick of 15cm. For diferent wall, the fixation
must be projected in the building work by qualified staff.
For fixing the wall plate, use the provided template to mark the holes and level
it according to template. Four holes Ø10 mm and a depth of 80 mm. The height
of the lamp will depend on the work area. It should remain at a distance of
approximately 80/100 cm from its workspace. If necessary, you can adjust the
height cutting the vertical arm nº 8. It is recommended to install it between
170cm and 200cm from the floor.
Once the holes are made, introduce the plug Nº 10 and attach the mounting
plate Nº 11 using the washers Nº 12 and screws Nº 13. Check the level of the
lamp before. Finally mount the embellisher nº 9.

4.2.2. - ELECTRICAL INSTALLATION

The electrical installation of the room where you plan to use the equipment should be in accordance with the rules UNE
(CIS), as well as the Low Voltage Regulation.
The plug socket where the equipment is going to be connected must be suitable for plugs according to standard rules
UNE 20315 and / or DIN 49441, with terminals of 4'8 mm and lateral earthing.
Fig. 2 – Wall plate installation.
Página 7 de 11