9. At this point you can attach the Tomato
Press & Sauce Maker to your work space.
If utilizing the Suction Cup, be sure the area
you wish to adhere to is smooth, clean, and
dry. Simply raise the Suction Cup Lever and
hold the Tomato Press & Sauce Maker firmly
in place with the Suction Cup in contact with
the table surface, then press the Suction
Cup Lever down. The Suction Cup Lever
will require firm pressure to lock it into place.
NOTE: If you have a rough or dirty surface,
the Suction Cup may not adhere to the
surface.
10. If utilizing the C-Clamp, simply position
the Tomato Press & Sauce Maker near the
edge of a table or counter. Slide the top end
of the C-Clamp into the slot at the base of the
Tomato Press & Sauce Maker and tighten the
screw to the underside of the work surface.
11. Slide the Handle into the Tomato Press &
Sauce Maker making sure to align the slots in
the Drive Shaft to the tabs on the Handle.
12. Attach the Waste Funnel to the end of
the Screen by pushing the small end with the
tabs over the end of the Screen. NOTE: Use
caution not to break the Waste Funnel when
attaching or detaching.
13. Attach the Squirt Guard/Chute to the
Screen by sliding the Squirt Guard/Chute
over the Screen with the larger opening of the
Squirt Guard/Chute closest to the Hopper.
Snap it into place. FIGURE F
14. Attach the Hopper to the top of the Roma
by sliding the small neck section of the Hopper
into the throat of the Body.
15. Before placing any food in the Hopper
be sure to have a bowl or jar under both
the Waste Funnel and the Squirt Guard/
Chute. FIGURE G
WARNING!
NEVER use
fingers to
push food into
the Hopper.
ALWAYS use
the provided
Stomper.
FIGURE F
FIGURE G
7