Cleaning And Maintenance - Black and Decker Dustbuster AV1210 Manual De Usuario

Assembly
Fitting the accessories (fig. C & D)
The appliance is supplied with the
following accessories:
a hard brush (5) for upholstery

a crevice tool (6) for confined spaces

The accessories are stored beneath the
rear of the appliance.
To fit an accessory, proceed as follows:
Take the accessories from the

appliance.
Insert the appropriate accessory into

the front of the appliance.
AV1260 - Additional accessories
(fig. E & F)
an extension hose (7) and a hose

connector (8)
a brush (9) for carpets and upholstery

an extended crevice tool (10) for the

most difficult to reach areas
When not in use, the appliance and the
accessories can be stored in the storage
bag (11).
To fit an accessory, proceed as follows:
Fit the hose connector onto the nose

of the appliance.
Attach one end of the hose to the

connector.
Attach the appropriate accessory to

the other end of the hose.
Use
Connecting to the vehicle's power
supply (fig. A)
Make sure that the appliance is

switched off.
Remove the cigarette lighter from the

socket.
Plug the connector (4) into the

cigarette lighter socket.
Operating the appliance (fig. B)
To switch on, slide the on/off switch

(1) forward.
To switch off, slide the on/off switch

back.
ENGLISH
The appliance can be used for periods of
up to 30 minutes without noticeably
affecting the power of a normally charged
car battery in good condition.
Warning! Extended use will drain the
battery power. Do not run the vehicle's
engine while cleaning. This can shorten
the life of the appliance.
Troubleshooting
If the product does not work, follow the
instructions below. If this does not solve
the problem, please contact your local
Black & Decker repair agent.
Make sure the connector (4) is

plugged into the cigarette lighter
socket correctly.
Make sure your vehicle battery

system is of the 12 V negative
ground type (see "Electrical safety").

Cleaning and maintenance

Warning! Regularly clean the filters.
Cleaning the dust bowl and filters
(fig. H-K)
The filters are re-usable and should be
cleaned regularly.
Press the release button (2) and

remove the dust bowl (3) (fig. G).
Empty the dust bowl (fig. H).

Remove the filters (12 & 13) by

twisting them clockwise (fig. I).
Brush any loose dust off the filters.

Wash the filters in warm, soapy water

(fig. J). The bowl can also be washed
if necessary (fig. K).
Make sure the dust bowl and filters

are dry.
Refit the filters (12 & 13) onto the

appliance, twisting them
counterclockwise until they lock into
place.
Refit the dust bowl onto the

appliance. Make sure the dust bowl
clicks into place.
Warning! Never use the appliance
without the filters. Optimum dust
collection will only be achieved with clean
filters and an empty dust bowl.
5