Cleaning And Maintenance - Black and Decker PV9605 Traducción De Las Instrucciones Originales

Health hazards caused by breathing dust developed

when using your tool (example:- working with wood,
especially oak, beech and MDF).
Use
Before first use, the battery must be charged for at least

24 hours.
Place the appliance on the charging base whenever it is

not in use.
Charging the battery (fig. E)
Make sure that the appliance is switched off. The

battery will not be charged with the on/off switch in the
on position.
Place the appliance on the charging base (7) as shown.

Plug in the charger. Switch on at the mains.

The charging indicator (6) will be lit.
Leave the appliance to charge for at least 24 hours.

While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance can
be left connected to the charger indefinitely. The charging
indicator (6) will be lit as long as the appliance is connected
to the plugged-in charger.
Warning! Do not charge the battery at ambient
temperatures below 10°C or above 40°C.
Switching on and off (fig. F)
To switch the appliance on, slide the on/off switch (4)

forward to position 1.
For full power, slide the on/off switch (4) forward to

position 2.
To switch the appliance off, slide the on/off switch (4)

back to position 0.
Optimising the suction force (fig. G - I)
In order to keep the suction force optimised, the filters must
be cleared regularly during use.
Rotate the wheel (5) a few turns to shake out dust

clogging the filters (14 & 15).

Cleaning and maintenance

Warning! Regularly clean the filters (14 & 15).
Cleaning the dust container and filters (fig. H - J)
The filters are re-usable and should be cleaned regularly.
Press the release latch (1) and open the container

door (2) (fig. H).
Empty the dust container.

Remove the filters (14 & 15) by twisting them counter-

clockwise (fig. I).
Brush any loose dust off the filters.

Wash the filters in warm, soapy water (fig. J).

Make sure that the filters are dry.

Refit the filters (14 & 15) on to the appliance,

twisting them clockwise until they lock into place.
Close the container door (2). Make sure that the release

latch (1) clicks into place.
Warning! Never use the appliance without the filters.
Optimum dust collection will only be achieved with
clean filters.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged. Replacement filters are
available from your Black & Decker dealer (cat. no. VF50):
Remove the old filters as described above.

Fit the new filters as described above.

Maintenance
Your Black & Decker corded/cordless appliance/tool has
been designed to operate over a long period of time
with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular
cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.

Or switch off and remove the battery from the appliance/

tool if the appliance/tool has a separate battery pack .
Or run the battery down completely if it is integral and

then switch off.
Unplug the charger before cleaning it. Your charger

does not require any maintenance apart from regular
cleaning.
Regularly clean the ventilation slots in you appliance/tool/
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust from
the interior (when fitted).
ENGLISH
9