Connecting The Components - baxiroca G 1000-11 Instrucciones De Instalación

4 Boiler Start-up
4.1

Connecting the components

Make the electrical connection between the control panel
and the various components:
- Valves (9-way connector).
- Optional gas pressure switch (6-way connector).
- Wire the ignition cable (left-hand electrode) and the
flame sensing cable (right-hand electrode) to the pilot
burner assembly.
- Insert the thermostat and thermometer bulbs in the pocket
as shown in the diagram below.
Valves connection
Control thermostat bulbs
Ignition plug
Flame sensing rod
Pocket
KSF CE control panel
1
2
4
3
When fitting the capillaries, ensure they are inserted fully
in the glove finger.
1 - Overheating safety thermostat
2 - Heating outlet thermometer
3 - Regulation thermostat
4 - Heating regulation probe
Optional gas
pressure s witch
(6-way connector)
KSF control panel
Spring
1
4
Valves
(9-way connector)
45