Consumer Safety Information; Cleaning & Maintenance - Holmes HFH111T Manual De Instrucciones

F E AT U R E S - O P E R AT I O N S
C L E A N I N G / M A I N T E N A N C E

CONSUMER SAFETY INFORMATION

(For 120 NEMA 1-15P plugs only) This appliance has a
polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug will fit in a
polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. DO NOT MODIFY THE PLUG
IN ANY WAY.
OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Make sure the unit is in the Off ( ) position before
plugging the heater into the outlet.
3. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet.
Mode Control
Turn the Mode Control to the desired setting:
- Off Mode
If you want to shut off the heater at any time during
operation, turn the Mode Control to Off ( ) position.
Power Light will remain lit until heater is turned to
Off ( ).
- Fan only Setting
Heater will run at fan-only without heat output.
1 - Low Heat
The heater will run continuously at 1000W.
Figure 1
A. Power Light
B. Mode Control
C. Carry Handle (not
shown)
D. Thermostat Control
D
C
2 - High Heat
The heater will run continuously at 1500W.
NOTE: To start heater operation, make sure the
Thermostat Control is turned fully clockwise to the highest
position.
Thermostat Control
1. Before setting the thermostat, allow heater to operate
and warm up the room. Turn the Thermostat Control
clockwise to High to start the heater.
2. When the desired temperature comfort level is
reached, lower the thermostat setting until the fan/
heater stops operating. This is done by moving the
Thermostat Control counterclockwise toward the Low
setting.
3. The control will now automatically maintain the
pre-set temperature level by cycling the heater ON
and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, raise the thermostat setting.
CAUTION: FRONT GRILL IS HOT WHEN UNIT IS IN
OPERATION.
CLEANING/MAINTENANCE
Always unplug the heater before cleaning and allow the
heater to cool down.
1. Clean the unit with a soft cloth moistened with a mild
soap solution.
2. NEVER use abrasive or flammable solvents to clean
the unit.
3. After cleaning, be sure to completely dry the unit
with a cloth or towel.
4. Store heater in a cool, dry location.
B
5. It is recommended that you store the unit in its
original carton.
A
TIP: Over time, dust may accumulate on the front
grills. This can be removed by wiping the unit with a
damp cloth.