Briteq BT-W30FC Mk2 Manual De Instrucciones página 11

ENGLISH
 To assure proper operation you need an optional "Mini DMX-SPLITTER" (order code: 4630) to isolate
the master/slave line from the main DMX-line, see drawing.
 Connect 2 to maximum 16 units together using good quality balanced microphone cables. The first unit
in the chain will act as the master, the other units will act automatically as slaves.
 Set the master to 1MSL or 4MSL channel mode (see previous chapter). Check the DMX-chart below to
see the difference between both channel modes.
 For the DMX-controller the master and his slaves can now be considered as 1 virtual effect that needs a
start address so it can be controlled as any other DMX-unit in the DMX chain: see "DMX Address" in the
chapter "Main Menu" to see how you can set the DMX-start address.
 Make sure that all units are connected to the mains.
 Set the DMX-controller according to the DMX-chart below.
 Done!
Remark: in order to work well to the rhythm of the music, make sure that the option "Sound State" on the
master is set to "On" (see previous chapter)
DMX-Chart for 1MSL and 4MSL working modes
1MSL mode
Electrical installation in DMX-mode:
 The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected units with a good quality balanced cable.
 Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these
cables are compatible with balanced audio cables.
Pin layout XLR-3pin:
(+)
Pin layout XLR-5pin:
(+) ~ Pins4+5 not used.
 To prevent strange behavior of the light effects, due to interferences, you must use a 90Ω to 120Ω
BRITEQ
®
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal
4MSL mode
9/68
OPERATION MANUAL
BT-W30FC Mk2