Control Panel - Briteq BT-W30FC Mk2 Manual De Instrucciones

ENGLISH
HOW TO SET UP THE UNIT

CONTROL PANEL:

1. DISPLAY shows the various menus and the selected functions.
2. LEDS
3. BUTTONS
4. REMOTE CONTROL INPUT: Used to connect a simple CA-8 hand controller while the unit is used in
standalone or master/slave mode.
5. SENSITIVITY: Used to adjust the sensitivity of the micro when the unit is used in standalone or
master/slave mode.
6. DMX INPUT/OUTPUT: used for DMX512 linking. Use good quality 3pin XLR M/F balanced cable to link
the units together.
7. MAINS INPUT: with IEC In/out socket including an integrated fuse holder, connect the supplied mains
cable here. The BT-W30FC Mk2 can be daisy chained up to 12 pieces.
MAIN MENU:
 To select any of the functions, press the MENU button up to when the required one is shown on the
display or use the DOWN and UP buttons to browse the menu.
 Select the function with the ENTER button (the display blinks).
 Use DOWN and UP buttons to change the mode.
 Once the required mode is selected, press the ENTER button to confirm.
To go back to the main menu without any change press the MENU button shortly. The main menu is shown
in the chart.
DMX512 Address Setting
Used to set the starting address in a DMX setup.
 Press the MENU button until
 Press the ENTER button, the display starts blinking.
BRITEQ
®
DMX On
MASTER On
SLAVE On
SOUND Flashing
MENU To select the programming functions
DOWN To go backward in the selected functions
UP To go forward in the selected functions
ENTER To confirm the selected functions
is shown on the display.
DMX input present
Master mode
Slave mode
Sound activation
4/68
OPERATION MANUAL
BT-W30FC Mk2