Install The Boundary Wire - Guardian Fence Guía De Uso

Correction. After hearing the beep, continue to walk towards the
wire. The Receiver Collar should tick and the Test Light should fl ash,
indicating the Static Correction as you enter the Static Correction
Zone (6E). A warning tone and the fl ashing of the Test Light indicate
that the Receiver Collar and the system are working properly. Test
in a number of different areas until you are satisfi ed that the system
is functioning properly. Next, walk all around the Pet Area to ensure
there are no areas where the Receiver Collar may activate from
signals coupled onto buried wires or cables. Test the collar in and
around the inside of the house as well. As mentioned, cable and
wires from cable TV, electrical or telephone lines may conduct pet
fencing signals inside and outside the house that can activate the
dog's collar accidentally. While rare, if this occurs your Boundary
Wire is probably too close to these outside lines and should be
moved or modifi ed as shown in Figure 3A.
If you are satisfi ed that your system is functioning properly, you are ready to start burying the
Boundary Wire. If the Receiver Collar did not beep or the Test Light did not fl ash, see the
"Troubleshooting" section.
Note: The Boundary Width is broken down into 20% Warning Zone and 80% Static Correction Zone.

Install the Boundary Wire

Step
7
Important: Before you begin installing the Boundary Wire, unplug the adapter from
the transmitter.
To Bury the Boundary Wire
Burying the Boundary Wire is recommended to protect it and prevent disabling the system.
1. Cut a trench
2. Place the Boundary Wire into the trench maintaining some slack to allow it to expand and
contract with temperature variations.
3. Use a blunt tool such as a wooden paint stick to push the Boundary Wire into the trench. Be
careful not to damage the Boundary Wire insulation.
To Attach the Boundary Wire to an Existing Fence
The Boundary Wire of the Guardian
split rail fence, or a wooden privacy fence. The Boundary Wire can be attached as high as needed.
However, make sure the Boundary Width is set at a high enough range for the pet to receive the
signal. If using a Double Loop with an existing fence at least 5 feet tall, run the Boundary Wire on
top of the fence and return it on the bottom of the fence to get the 5 foot separation needed.
• Chain Link Fence (7A):
Boundary Wire through the links or
use plastic quick ties.
• Wooden Split Rail or Privacy
Fence (7A): Use staples to attach
Boundary Wire. Avoid puncturing
the insulation of the Boundary Wire.
• Double Loop with an Existing
Fence: Run the Boundary Wire on
top of the fence and return it on the
bottom of the fence to get the 5 foot
separation needed.
• Gate (Single Loop) (7B):
Boundary Wire in the ground across
the gate opening. Note: The signal is
still active across the gate. Your pet cannot pass through an open gate.
• Gate (Double Loop) (7B):
them 5 feet apart.
1-3 inches deep along your planned boundary.
®
Weave
Bury the
Bury both Boundary Wires across the gate opening while keeping
www.guardianpet.net
Underground Fence
®
7A
WEAVE WIRE INTO FENCE
STAPLE WIRE TO FENCE
STAPLE WIRE
TO FENCE
6E
can be attached to a chain link fence,
7B
SINGLE LOOP
5'
DOUBLE LOOP
Boundary
Wire
5'
11