Connect The Wires To The Fence Transmitter; Surge Protection; Prepare The Receiver Collar - Guardian Fence Guía De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3E
Additional Boundary Wire
Extra direct burial Boundary Wire can be purchased in 500 foot spools at the store where you
purchased the kit or through the Customer Care Center.
Note: When adding Boundary Wire, it must act as a continuous loop.
The table at right indicates the approximate length of
Boundary Wire needed for a square, Single Loop layout.
Length will vary due to the amount of twisted wire and
layout used.

Connect the Wires to the Fence Transmitter

Step
4
Boundary Wire (4A)
1.
Run the Boundary Wire to the Fence Transmitter through a window,
under a door, through a crawl space vent, or any other appropriate
available access. You can also drill a hole through your wall.
2.
Strip the ends of the Boundary Wire approximately one-half inch.
3.
Insert the Boundary Wires into the Boundary Wire Terminals on
the Fence Transmitter. Make sure wires do not touch each other
at terminals.
4.
Turn the Boundary Width Control knob to 10. This will set the
Warning Zone at the maximum width.
5.
Plug the Power Adapter into the Power Jack and a 120-volt outlet.
6.
The Power Light and Loop Indicator Lights should come on. If
this does not happen, see the "Troubleshooting" section.

Surge Protection

Lightning strikes within 1-2 miles of your installation can create power surges or spikes which
may damage your unprotected electronic pet containment system. The LP-4100-1 Surge
Protector is designed to protect your Underground Fence from surges or spikes that can reach
it via your AC power connection and /or your buried Boundary Wire.
Important: Standard Surge Protectors will not protect the transmitter because they do not
contain protection for the Boundary Wire. Nearly all damage to the transmitter results from
power surges or spikes traveling through the Boundary Wire and not the power adapter.
You may purchase a Surge Protection Kit through the Customer Care Center. The Surge
Protection Kit protects the system against surges that travel through the power source and/or
the Boundary Wire.

Prepare the Receiver Collar

Step
5
Your Receiver Collar comes with short Contact Points. Long Contact
Points for pets with long or thick hair are available through our Customer
Care Center. Tighten the Contact Points with Test Light Tool one-
half turn beyond fi nger tight (5A). Check the tightness weekly. Before
inserting the batteries, wipe the outer edge of the battery door with a
clean cloth to remove any dirt or debris.
8
3F
Customer Care Center 1-800-732-2677
3G
Acres
Feet of Wire Needed
1/4
415
1/3
480
1/2
590
1
835
2
1180
5
1870
4A
Boundary
Width
Control
Power
Light
}
Boundary
Wire
Terminals
5A
Power
Jack
Loop
Indicator
Light

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido