AQUALUX ALPHA Manual De Instrucciones página 13

Insert the sheathes by hand, and then drive them in using a mallet. They should not protrude beyond the
coping.
Position the tube on the steps and lock it into position by inserting the specific bolts. It is locking the
tube into position that will enable you subsequently to place the step module under tension.
Pool side
Step
side
Insert the side strap on each side of the tube on the coping support.
Continue fitting the pool cover, then finish fitting the step from STEP 7.
STEP 3
Have somebody hold the cover on the storage side (if you are on your own, use salt or sand bags) while
another person unrolls it using the central unrolling strap.
STEP 4
Centre the cover over the pool with at least 20 centimetres resting on the coping all around the edge.
Offset it by a few centimetres lengthwise in order to make up for the fact that it will stretch when made
taut using the ratchets.
When there are steps along the length, cover the support bar.
NOTCOUVEGA – ind F FRGBSP
Step side
Sheath
Step side
Unrolling
Centring
45°
Pool side
Pool
side
13 / 24
Pool side
Step
side