Installing The Tv To The Wall - Sony BRAVIA KDL-50W82xB Serie Guía De Referencia

Installing the TV to the Wall

Sufficient expertise is required for installing this product. Be sure to subcontract the installation to Sony
dealers or licensed contractors and pay special attention to safety during installation. Sony dealers or
licensed contractors should read this instruction manual thoroughly to do the installation work safety. Sony
is not liable for any damages or injury caused by mishandling or improper installation, or installing any
other than the specified products. Statutory Rights of the customers (if any) are not affected.
Your TV's Table-Top Stand will be used as a part of the Wall-Mount Bracket.
Note
• See page 3 (Safety information) and page 5 (Precautions) on WALL-MOUNT BRACKET before carrying out Wall-Mount
Bracket installation.
• If the Table-Top Stand is attached to the TV, detach the Table-Top Stand beforehand.
• Place the TV with its screen facing down on a flat and stable surface covered with a thick and soft cloth that is larger
than the TV, when securing the Stand or when removing the Table-Top Stand from the TV to prevent damaging the
surface of the LCD display.
• Once the Stand Necks are detached from the Stand, be sure to keep the Stand Necks and screws in a safe place.
• When attaching the Table-Top Stand again, be sure to fasten the screws (previously removed) to the original holes
on the rear of the TV.
• Be sure the TV is on the vertical position before switching on. TV set must not powered on with LCD panel face down
to avoid uneven picture uniformity.
To detach the Table-Top Stand from the TV
Soft cloth
Stand Necks
Stand
GB
7 GB