Instructions For Use - Bebesounds MO141 Manual De Instrucciones

49MHz-Manual 10/17/05 11:25 AM Page 4

INSTRUCTIONS FOR USE

1. Select either AC or battery power (see below).
4
2. Turn both units on making sure they are set to the same channel. To change the
channel, slide the Channel/Power switch to either the A or B position on both units
(See Fig. 1).
3. Adjust the volume control on the Parents' Unit.
4. Adjust the optional Voice Activation on the Nursery Unit (See Fig. 2). Activating
this feature may avoid the transmission of some background sounds that don't
pertain to your baby. Adjust the sensitivity of the Voice Activation to your preference.
Using AC Power
1. Plug the AC adapter into the right side of each unit (See Fig. 3).
2. Plug the AC adapter into the outlet in your wall.
3. Use only the BébéSounds® adapters included with the monitor. Do not use these
adapters with any other equipment.
Using Battery Power
1. Using a very small Phillips head screwdriver, unscrew the cover of the battery
compartment and slide down and off (See Fig. 4).
2. Insert one 9-Volt battery by snapping it to the black tab inside the compartment.
3. Replace the cover and tighten the screw.
4. Replace the batteries every 6 months or as needed.
Note: It is recommended that you keep batteries in your monitor at all times in case of a
power outage.
All manuals and user guides at all-guides.com
Fig. 1
Fig. 3
Fig. 2
Fig. 4
5