Troubleshooting; Technical Specifications; Fcc Information - Bebesounds MO141 Manual De Instrucciones

49MHz-Manual 10/17/05 11:25 AM Page 8

TROUBLESHOOTING

Note: Because this sound monitor is wireless, it is possible that similar products in
your home or neighborhood may interfere with the reception. In the event of inter-
8
ference, change the channel on both the receiver and the transmitter. Remember,
they both must be on the same channel for the monitor to operate properly.
Problem
You are receiving no sound.
You are receiving a lot of
static.
You are receiving a constant
humming sound on your
receiver.
The sound is very weak.
You are getting a shrill sound.
It sounds like your monitor is
turned off but it is on.
For additional troubleshooting, please contact BébéSounds
Monday – Friday at 1-888-232-6476, 9:00AM – 5:00PM EST
All manuals and user guides at all-guides.com
Solution
Check that the AC adapters are plugged into working out-
lets. If using batteries, check that they are properly
installed and/or replace them.
Check that both the transmitter and receiver are set to the
same channel and they are within the transmission range.
Switch the Voice Activation feature on. This will eliminate
background noise but it will automatically turn on the
transmitter if your baby makes noise.
Check volume setting on receiver. Check that there is
nothing obstructing the transmitter or receiver. Check for
dead batteries if using battery power.
Increase the distance between the transmitter and receiver.
Lower the volume on the receiver.
Check the Voice Activation feature. If it is on, you may
choose to turn it off.
® Technical Support,

TECHNICAL SPECIFICATIONS

No. of Channels: 2
Power Supply: One 9-Volt battery for each unit (not included) or one 9V AC/DC
adaptor for each unit (included).
Frequencies: Channel A: 49.83Mhz and Channel B: 49.835Mhz.

FCC Information:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1) this device may not cause harmful interference, and (2) this device must accept any inter-
ference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for
compliance will void the user's authority to operate the equipment. Any change to the equipment will
void FCC grant.
This equipment has been tested and found to comply with the limits for a Class C digital device, pur-
suant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection agains
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
9