Display; Temperature Setting - Kenmore 580.74184 Manual Del Propietário

DISPLAY
REMOTE CONTROL SIGNAL RECEIVER
TEMPERATURE SETTING
• This button can automatically control the
temperature of the room.
The temperature can be set within a range
of 640F to 820F.
• Every time you push TEMP down button, it
advances the Mode setting as flows:
• (82OF) ,.. (760F) .... (70OF)
.... (640F).
• Every time you push TEMP up button, it
advances the Mode setting as flows:
.... (640F) .... (70OF) _.. (76OF)
• (82OF).
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, Timersets number of hours untilshut-off.
• Everytime you pushTimerbutton,it advancesthe Timersetting
as follows:1 Hour(1Hour-2 Hours) _3 Hours(3Hours- 5
Hours) * 6 Hours(6Hours~ 9 Hours) .10 Hoursmaximum.
- STARTTIME
• If unit is off, Timer sets number of hours before unit starts.
POWER
• To turn the air conditioner ON, push the button.
To turn the air conditioner OFF, push
the buttonagain.
• This button takes priority over any other button.
• When you first turn it on, the air conditioner is on
the High cool mode and the Temp, at 70°F,
• Everytime you push Timer button, it advancesthe Timer setting as follows: 1 Hour(1Hour~2Hours) _3 Hours(3Hours~ 5
Hours) _6 Hours(6Hours~ 9 Hours) dO Hoursmaximum.
MODE
• Every time you push this button, it will shift among COOL - HI, COOL - LOW, FAN ONLY - HI, FAN ONLY -
LOW.
In failure of electric power, the unit runs as previous setting operation.
J
HORIZONTAL AIR DIRECTION CONTROL
The horizontal air direction is adjusted by moving
the vertical louvers right and left with your
fingertips. (FIG. 24)
VERTICAL AIR DIRECTION CONTROL
The vertical air direction is adjusted by moving the
horizontal louvers up and down with your fingertips.
(FIG. 25)
FIG. 24
FIG. 25
-11 -