Unpacking; Disposal Of The Packaging; Setup Location Requirements - CASO DESIGN 3298 Manual De Instrucciones

14.3 Unpacking

Unpack your ice maker as follows:
 Take out the ice maker from the box and remove the interior and exterior packaging.
 Leave the device to stand in its final location for at least 24 hours after unpacking or
transporting it. The coolant in the device requires this amount of time to settle.

14.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to "Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

14.5 Setup location requirements:

 In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity.
 Do not leave the device to direct sunlight.
 Choose the setup location in such a way that children cannot reach the device.
 The device is not intended to be installed in a wall or a built-in cupboard.
 Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 10 cm on all sides.
 Do not cover any ventilation openings of the device and do not block them.
 Do not remove the device's adjustable feet.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
Please note
34