Disposal Of The Packaging; Setup Location Requirements; Electrical Connection - Caso KM 1200 CHEF Manual Del Usuario

15.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and
recycling-related points of view and can therefore be recycled. Returning the
packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste.
Take any packaging materials that are no longer required to "Green Dot" recycling
collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

15.5 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 Place the device on a firm and even work surface.
 Do not use the device outdoors.
 The device is not intended to be installed in a wall or a built-in cupboard.
 The device requires adequate air circulation (minimum distance 15 cm).

Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.

15.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
Caso Küchenmaschine KM 1200 Chef
Please note
45