H.Koenig VIX9 Manual De Utilización página 2

ENGLISH
1. Make sure to read all the safety precautions below and look at the illustrations
before you start using the appliance.
2. Use the appliance for its intended use only described in this manual.
3. The appliance is intended for household use only.
4. In order to protect against the risk of electric short, do not immerse iron power
base into water or any other liquids.
5. Connect the appliance only to an alternating current of the voltage specified on
the rating plate and only to an earthed socket. To avoid a circuit overload, do not
operate another high wattage appliance in the same circuit.
6. Turn the appliance to OFF before plugging or unplugging from outlet. Never yank
cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
7. Do not allow power cord or supply hose to touch hot surface.
8. Unplug the appliance from main socket before filling or empty or when not in use.
9. Do not operate the appliance with a damaged cord or if the appliance has been
dropped or damaged. To avoid a hazard such as the risk of
not disassemble the appliance, it must be taken to a qualified serviceman or
manufacturer or its service agent for examination and repair. Incorrect re-assembly
can cause a risk of electric shock when the iron is used.
10. Place the iron out of reach of children; close supervision is necessary for any
appliance being used by or near children. Do not leave the iron unattended while
connected to the supply mains.
11. During use, always place its stand on a stable, level and horizontal surface or
ironing board.
12. Always place the iron on its stand, and do not allow the hot soleplate touch
power cord or supply hose.
13. Burns can occur from touching hot metal parts, hot water or steam. Use caution
when using the appliance.
14. Never use the iron facing towards people because the steam can cause burns.
15. The surfaces are liable to get hot during use.
16. Never twist the supply hose during use.
17. The appliance must be used and rested on a stable, level and horizontal surface.
18 .The iron shall be placed on the separate stand only.
19. When placing the iron on its stand, ensure that the surface on which the stand is
placed is stable.
20. The iron is not to be used if it has been dropped, if there are visible signs of
damage or if it is leaking.
21. The iron must not be left unattended while it is connected to the supply mains.
22. The appliance must be rest or stocked in a on a stable, level and horizontal
surface.
23. During use, if no water in the reservoir, it will produce noise>70dBA.
electric shock, do