Use And Care; Personal Safety; Spraying Precautions; Air Source - Campbell Hausfeld ET200000 Manual De Instrucciones Y Lista De Piezas

Operating Instructions and Parts Manual
Important Safety Information (Continued)

PErsonal saFETy

a. Stay alert. Watch what you are doing and use common
sense when operating the unit. Do not use the unit
while tired or under the influence of drugs, alcohol, or
medication. A moment of inattention while operating the
unit increases the risk of injury to persons.
b. Dress properly. Do not wear loose clothing or jewelry.
Contain long hair. Keep hair, clothing, and gloves away
from moving parts. Loose clothes, jewelry, or long hair
increases the risk of injury to persons as a result of being
caught in moving parts.
c. Do not overreach. Keep proper footing and
balance at all times. Proper footing and
balance enables better control of the unit in
unexpected situations.
d. Use safety equipment. A dust mask, non-skid
safety shoes and a hard hat must be used for the
applicable conditions. Wear safety glasses and
use hearing protection when operating the unit.
Ensuring that the unit is used
only when the operator and all
other personnel in the work area are wearing ANSI Z87
eye protection equipment, and when required, other
appropriate protection equipment such as head, hearing
and foot protection equipment. Serious eye or permanent hearing
loss could result.

usE anD carE

a. Do not stand on or use the unit as a handhold.
b. Always work in a well-ventilated area. Wear OSHA-
approved dust mask.
c. Do not remove any labels from the unit.
Never use plastic (PVC) pipe for
compressed air. Serious injury or
death could result.
Drain tank every day to prevent
corrosion and possible injury due
to tank damage. Risk of bursting.
d. Tanks rust from moisture build-up, which weakens
the tank. Make sure to drain tank regularly and inspect
periodically for unsafe conditions such as rust formation
and corrosion.
e. Fast moving air will stir up dust and debris which may
be harmful. Release air slowly when draining moisture
or depressurizing the compressor system.
Never fill the tank above 150 psi. Personal
injury or property damage could occur.
Never fill from bottled gas or any air system
which produces over 150 psi.
f. Do not alter or tamper with the safety relief valve. In
the event that the safety relief valve is tampered with,
existing warranties shall be voided and Campbell
Hausfeld disclaims any liability whatsoever for any loss,
personal injury or damage.
NEVER attempt to repair or modify a tank.
Welding, drilling or any other modification
will weaken the tank resulting in damage from rupture or explosion.
Always replace worn, damaged or cracked tanks.
g. Release air pressure from air tank by pulling safety
relief ring before servicing or replacing parts.
Safety glasses must be worn
during operation.
h. For dry air only. Do not use to store or disperse
liquids or flammable gases.
i. Store inside. Do not store outside or in direct sunlight.
j. Only use attachments rated at 150 psi minimum.
k. Check air hoses for weak or worn condition before each
use. Make sure all connections are secure.

sPrayIng PrEcauTIons

Do not spray flammable materials
in vicinity of open flame or near
ignition sources including the compressor unit.
a. Do not smoke when spraying paint,
insecticides, or other flammable substances.
b. Use a face mask / respirator when spraying and spray in a
well ventilated area to prevent health and fire hazards.
c. Do not direct paint or other sprayed material at the
compressor. Locate compressor as far away from
the spraying area as possible to minimize overspray
accumulation on the compressor.
d. When spraying or cleaning with solvents or toxic
chemicals, follow the instructions provided by the
chemical manufacturer.

aIr sourcE

Air compressors providing air to the tank
should follow the requirements established by
the American National Standards Institute Standard B19.3-1991;
Safety Standard for Compressors for Process Industries. Contact
your air compressor manufacturer for information.

sErvIcE

Service must be performed only by qualified repair
personnel.
savE ThEsE InsTrucTIons
Do noT DIscarD
The DANGER, WARNING, CAUTION, and NOTICE
notifications and instructions in this manual cannot
cover all possible conditions and situations that may
occur. It must be understood by the operator that
common sense and caution are factors which cannot
be built into this product, but must be supplied by the
operator.
ET200000
5
www.chpower.com