Mounting; Mounting To The Wall; Connecting To Wall Mount Unit - Campbell Hausfeld ET200000 Manual De Instrucciones Y Lista De Piezas

Operating Instructions and Parts Manual

Mounting

MounTIng To ThE Wall

Establish where you plan to hang the
tank before starting to mount the tank.
Make sure that there is a stud in the
wall where you plan to locate the tank.
Use the bracket itself as a guide for
mounting.
The bottom of the mounting bracket
should be at least 20 inches above a
surface (floor or countertop). This will
allow easy access to the twist drain.
Make sure the mounting bracket is level.
Mark through the holes with a pen or
pencil.
Set the mounting bracket aside and pre-
drill holes with a 5mm or 3/16 inch drill
bit.
Place the mounting bracket back on the
wall (aligned with the pre-drilled holes)
and insert the included lag screws.
Tighten so that the mounting bracket is
held secure to the wall. Hang the tank
on the mounting bracket.
connEcTIng To Wall MounT
coMPrEssor unIT
Relieve all pressure
from wall mount unit
before replacing plug or attempting to connect
to wall mount compressor.
When establishing this unit as part of
a larger air system, proper connections
and placement must be considered. If
the
2-in-1 tank is being added to a pre-
existing wall mount compressor
unit, use Figure 5 as a guide on tank
placement. Follow the same mounting
instructions as given in the previous
section (this unit still needs to be
secured to a stud).
Attach the double check plug to the
hose and connect to the wall mount
compressor unit. The quick coupler
and plug on the end of the double
check valve hose assembly allows for
easy connection and disconnection of
the ET200000 expansion tank to the
WL675000 wall mount compressor.
8
> 20 inches
Figure 4
16 inches
Figure 5
Lag Screws
16 inches
Double Check Plug
ET200000