Hardware Installation; Wall Mount; Ceiling Mount - Grandstream GWN7600 Manual Del Usario

HARDWARE INSTALLATION

GWN7600 can be mounted on the wall or ceiling, Please refer to the
following steps for the appropriate installation.

Wall Mount

1. Position the mounting bracket at the desired location on the wall
with the arrow pointing up.
2. Use a pencil to mark the four mounting holes (screw holes DIA
5.5mm, reticle hole DIA 25mm).
3. Insert screw anchors into the 5.5 mm holes. Attach the mounting
bracket to the wall by inserting the screws into the anchors....
1 2
4. Connect the power cable and the ethernet cable (RJ45) to the cor-
rect ports of your GWN7600.
5. Align the arrow on the GWN7600AP with the arrow on the locking tab
of the mounting bracket and ensure that your GWN is firmly seated
on the mounting bracket.
6. Turn the GWN clockwise until it locks into place and fits the locking
tab.
4
Wall
Wall
PA3.5x20
PA3.5 x 20
Screw
Screw
3
Plastic Expansion
Bolt
Plastic Expansion
Bolt
5
~3~

Ceiling Mount

Note: Ceiling mounting is recommended for optimal coverage perfor-
mance.
1. Remove the ceiling tile.
2. Place the ceiling backing plate in the center of the ceiling tile and
mark the mounting screw holes (screw holes DIA 5.5mm, reticle
hole DIA 25mm).
3. Insert the screws through the mounting
1
4. Connect the Ethernet cable (RJ45) to the correct ports of your
GWN7600.
5. Align the arrow on the GWN7600AP with the arrow on the locking
tab of the mounting bracket and ensure that your GWN is firmly
seated on the mounting bracket and connect the network and power
cables.
6. Turn the GWN clockwise until it locks into place and fits the locking
tab.
4
6
bracket.
Ceiling
M3 nut
Mounting
2
M3.0x50 screw
5
~4~
3
6