Mounting The Shelf; Rubber Feet; Dust Shroud - WMH Tool Group JET 708315BTA Instrucciones De Operación Y Manual De Repuestos

Mounting the Shelf

Models LSA, LSB
Note: The shelf is easier to install when three legs
have been assembled. The fourth leg should be
assembled after this section is completed.
Required hardware (for assembling all four legs):
four M6 flange hex nuts (J).
Referring to Figure 3:
1. While the saw is still upside down, position the
shelf (A) between the three legs (B) and below
the legs' mounting tabs (D). The sides of the
shelf (D) should point down.
2. Bring the shelf up, positioning the tabs of shelf
(E) against the bottom of the mounting tabs on
the legs (C), and line up the mounting holes.
3. From underneath the shelf, insert a hex cap
screw (F) up through the mounting holes of the
shelf and leg tabs. Secure the threaded portion
of the screw protruding through the top side of
the leg mounting tab with a flange hex nut (J),
hand-tightening only at this time.
After the shelf is secured to all three legs,
assemble the final leg (described in previous
section) and then finish by securing the remaining
shelf tab to the leg as well.
Figure 3

Rubber Feet

Models LSA, LSB
Referring to Figure 4:
While the saw is still upside down,
1. Place rubber foot (B) on the leg (A), sliding
forward (1) while at the same time allowing the
rear tab (C) of the leg to slide through the
opening (D) in the heel of the rubber foot.
2. Press the foot down (2) until the foot "snaps"
into position on the leg.
3. Repeat for remaining three legs.
At this time, turn the saw right side up. Place on a
level surface and tighten all screws for the leg and
shelf assembly.

Dust Shroud

Model LSB only
Note: Install the dust shroud only if a separate dust
collection or vacuum system will be used.
Referring to Figure 5:
1. Place the dust shroud (A) inside the legs with
the port (B) towards the rear of the saw and
positioned down as shown.
2. Bring the front end of the shroud up so the two
front tabs (C) catch the lip (D) of the base,
securing it in position. The opening at the
corners of the shroud (E) should wrap around
the leg tabs (F).
3. Press the back of the shroud up until the rear
tabs snap into place against lip at the back of
the base.
11
Figure 4
Figure 5