Saw Blade; Attaching The Rip Fence; Calibrating The Rip Fence Scale - WMH Tool Group JET 708315BTA Instrucciones De Operación Y Manual De Repuestos

Saw Blade

All Models
The 708315 Table Saw comes with the saw blade
already included and installed from the factory. To
replace a blade, see Replacing the Blade in the
Adjustments section.

Attaching the Rip Fence

All Models
Referring to Figure 9:
1. Raise the rip fence handle (A) as shown.
2. Position the rip fence (B) over the table (C) as
shown, holding up the front end while engaging
the holding clamp (D) to the rear, then lowering
the front end (E) onto the rail (F).
3. Lower the handle (A) to clamp the fence to the
table

Calibrating the Rip Fence Scale

All Models
1. Attach the rip fence to the table (as described
in the previous section) to the right of the saw
blade, but do not lower the handle to clamp the
fence to the table.
2. Slide the fence against the saw blade.
You will need to raise the blade guard and the
anti-kick pawl to provide clearance for the
fence.
3. With the fence snug against the saw blade,
clamp the fence in position by lowering the
handle.
Referring to Figure 10:
The hairline on the indicator (A) should line up with
0" on the rail (C). If they do not line up:
4. Slightly loosen the screw (B).
5. Slide the indicator until the hairline lines up with
0" on the rail.
6. Tighten the screw.
13
Figure 9
Figure 10