Replacing/Adjusting The Drive Belt - WMH Tool Group JET 708315BTA Instrucciones De Operación Y Manual De Repuestos

Sierra de mesa de 10 pulgadas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing/Adjusting the Drive Belt

For Replacement and Adjustment
1. Remove the saw blade (see Replacing the
Blade on page 19).
2. Using the front handwheel, lower the blade
arbor to its lowest position (rotate handwheel
counterclockwise).
3. Remove the blade guard and splitter (see
Installing the Blade Guard and Splitter section
on page12), then turn the saw upside down.
4. Remove the dust shroud if applicable.
Referring to Figure 24:
5. With a 5mm hex wrench, loosen four socket
head cap screws (A) that secure the arbor
support (B) to the motor casing.
If adjusting belt tension only (no belt replacement),
skip steps 6 – 10 and proceed to step 11.
6. With a 10mm wrench, loosen the tension adjust
screw (C) by turning counterclockwise.
7. Push the arbor support (B) forward (D) to
relieve tension on the belt (E).
8. Remove belt (E) from the motor and arbor
pulleys (F, G).
9. Replace the old belt with a new belt making
sure that it sits properly on both pulleys.
10. Pull the arbor support (B) back (H), placing
tension on the belt, and hand-tighten the four
mounting screws (A).
Adjustment
11. With a 10mm wrench, turn the tension adjust
screw (C) to place proper tension on the belt.
Adjustment is sufficient when moderate finger
pressure on the belt between the pulleys
results in approximately 1/4" deflection.
12. Tighten the four mounting screws (A) with a
5mm hex wrench.
After the Adjustment
13. Replace
the
dust
applicable.
14. Turn the table saw right-side up.
15. Replace and adjust the blade guard and splitter
(refer to the Installing the Blade Guard and
Splitter and Adjusting the Blade Guard and
Splitter sections on page 12).
16. Replace the saw blade (Replacing the Blade
on page 19).
shroud
(page
11)
if
20
Figure 24

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Jet 708315btbJet 708315btcJet 708315lsaJet 708315lsb

Tabla de contenido