Kohler K-475 Guia De Instalacion página 9

7. Install the Towel Bar
IMPORTANT! Do not overtighten the setscrews. Overtightening can
damage the towel bar.
Use a hex wrench to thread a setscrew into each of the cylinder
inserts and tighten. Both cylinder inserts should face in the same
direction. The detent on both cylinder inserts should face straight
down.
Insert the cylinder head inserts into the skirts.
Use a hex wrench to insert a setscrew into both of the skirts.
Tighten the setscrews until the cylinder shafts are securely in
place.
8. Install the Glass Shelf
Slide a bracket assembly onto each end of the shelf. Make sure
both brackets are centered on the shelf and the setscrew holes are
on the same side.
Using a hex wrench, insert four nylon tipped setscrews
(provided) into the bracket assembly and tighten securely.
Install a cylinder head onto each stem of the bracket assembly as
shown.
Thread a setscrew into each cylinder head and tighten with a hex
wrench.
Measure the distance between the centers of the cylinder head
shafts.
Kohler Co. 9 1020823-2-A